You want to follow the journey - subscribe now

Retraction settings - one print to speed up calibration!

So you are looking for a way to calibrate the retraction-settings to your 3d-printer? We have a found one guy who had done a google-sheet to programmatically calibrate the retraction. This will test 16 different settings in ONE print. 

This is really good - instead of heating up the bed and print a 10 min print. You print this test cube. It will change the retraction speed from 10-150mm/sec and also how much retraction it should test. 

Here is a link to the guy who have created the google sheet. We will also put it up on our github account.

Happy retraction!

Leave a comment

Please note, comments must be approved before they are published